Combustibles are unavoidable on a horse farm, but how you manage them can considerably reduce the risk of a barn fire.

To help you learn more about the combustible hazards in your barn and evaluate the safety of your facility, visit Equine Guelph’s Barn Fire Prevention online tool. The interactive assessment tool asks 20 questions about inside and outside of your barn and takes five minutes to complete.

The chart below outlines some of the common fuel sources that burn rapidly once ignited and discusses best practices for prevention.

“Once you have reduced your risk (by) taking care of combustibles, inspect all possible sources of ignition,” says Equine Guelph director Gayle Ecker, PhD.

Electrical malfunctions are a primary ignition source for many fires including barns. Portable heaters are a risk as are other appliances not intended for agricultural use. When not in use, electrical equipment should be unplugged and properly stored away. It is important not to let water bucket heaters run dry; once empty, the continuous heat can melt the bucket resulting in ignition of stall bedding and hay.

An annual electrical inspection, completed by a qualified electrician familiar with livestock barns, is highly recommended to check for signs of deterioration or corrosion. The Electrical Safety Authority (ESA) has stringent requirements for installation of electrical equipment in animal confinement areas. Have any issues that are found repaired without delay.

Jim Zyta, vice-president of loss prevention for Heartland Farm Mutual, recommends:

– For additional protection against fire, especially in the animal housing area, consider arc-fault protection on 15 and 20 amp circuits and receptacles. This is especially important if your wiring is recessed within barn walls and above ceilings. Arc-fault protection could prevent a fire due to loose connections or rodent damage saving your building and more. – When using 240-volt “approved barn heaters” consult with your electrician and ESA inspector. It is a best practice to hardwire these units directly to a 30 amp circuit avoiding a receptacle connection. These 30 amp/250 V receptacles are notorious for burning up. – Always maintain clearances to combustibles as per manufactures installation guidelines.

Zyta says Heartland is happy to partner with Equine Guelph on this initiative, “We are helping barn owners protect what they value the most.”